12-29-2012, 10:24 AM
I've written a VB6.0 program with a lot of controls organized on frames. I moved all of the frames into tabs on the SSTab control. I was able to save the project and run it and everything was fine until it crashed. The crash was related to a board in the computer that the program was accessing. When I tried to load the project again the SSTabs were not able to load. Apparently, SSTab was not registered correctly and now I get an error to that affect. The real problem is that all of the controls I had put into the Tabs are now not visible. But in the Properties List they are still shown. And the program runs fine although I can't find any of the controls that have been placed on the Tabs. How do I make them reappear???