Yep a plug not connected would make it run really rough. A full miss on a 6 cylinder i suspect would cause a big drop in power.
If its simply moisture in the brake line (doubt it) then its a simple bleed.
Here is my trick.
Get a piece of air tube for a fish tank. Like the clear stuff for air pumps.
Put a 10mill or whatever your slave cylinder bolt size is and put that over the hose.
Put the hose over the bleeder. And then put the bleeder hose into a half full bottle of break fluid.
Then take top off break booster/filler area.
Now open bleeder bolt on slave and then pump the break peddle a few times making sure hose is under level of fluid in the bottle.
Do this a few times and problem gone.
If you need more on this then ask. Im a bit pissy currently and may be a bit off on my spelling an punctuation!!!!!
As for hijacking. I did ask you to start another thread so i blame you entirely lol.
Na takes away from my earlier post and thats important lol.
If its simply moisture in the brake line (doubt it) then its a simple bleed.
Here is my trick.
Get a piece of air tube for a fish tank. Like the clear stuff for air pumps.
Put a 10mill or whatever your slave cylinder bolt size is and put that over the hose.
Put the hose over the bleeder. And then put the bleeder hose into a half full bottle of break fluid.
Then take top off break booster/filler area.
Now open bleeder bolt on slave and then pump the break peddle a few times making sure hose is under level of fluid in the bottle.
Do this a few times and problem gone.
If you need more on this then ask. Im a bit pissy currently and may be a bit off on my spelling an punctuation!!!!!
As for hijacking. I did ask you to start another thread so i blame you entirely lol.
Na takes away from my earlier post and thats important lol.